UR5FFR

Радиолюбительские конструкции и программы
It is currently 20 Oct 2018, 11:03

All times are UTC + 2 hours




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: 23 Sep 2018, 20:31 
Offline

Joined: 15 Aug 2018, 09:29
Posts: 2
Hello Andrey,

I built this project and ran the latest software for NWT and it does not work. Whatever I do, I am just getting a straight line.

Please help.

Also , please incorporate a Stop button after you give a RUN command. The program hangs when you give a run command with a long Sample read.

vu2upx


Top
 Profile  
Reply with quote  
PostPosted: 23 Sep 2018, 21:29 
Offline
Site Admin

Joined: 21 Apr 2012, 21:00
Posts: 402
Location: Odessa
Позывной: UR5FFR
Hi,

1st check crystal freq in NWT.ino. It must be equal to used crystal. Also note that you need calibrate device before measurement


Top
 Profile  
Reply with quote  
PostPosted: 24 Sep 2018, 00:05 
Offline

Joined: 15 Aug 2018, 09:29
Posts: 2
Relayer wrote:
Hi,

1st check crystal freq in NWT.ino. It must be equal to used crystal. Also note that you need calibrate device before measurement


I did check the Crystal Frequency, its OK.

For Calibration I just shorted the Signal out with Singnal In and still a clean straight line.

I also simply ran the Run command on a out of board NaNo and still a straight Line.

which is the latest ino file for NWT Lite ?

Thank you for the reply


Top
 Profile  
Reply with quote  
PostPosted: 24 Sep 2018, 20:59 
Offline
Site Admin

Joined: 21 Apr 2012, 21:00
Posts: 402
Location: Odessa
Позывной: UR5FFR
Latest ino file in firsp post of this topic. I haven't idea why NWT isn't working. If you have oscilloscope you can doing next:
1. connect in to out
2. run Arduino IDE. open COM-port monitor. select baud rate 115200.
3. close and open com-port monitor again. NWT reply firmware version
4. enter command
f3000000<enter>
5. check that 3MHz freq found on the output
6. check that aftre ceramic filter found sin wave with freq equal to center of IF filter
7. check same freq after 2nd IF filter
8. check voltage at output of AD8307. it must be approx 2-2.2v


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group